Backhoe Equipment
JCB 4CX Backhoe Loader - 4X4, 2.3 meters wide - 4 wheel steer & 4 wheel drive, extender hoe with 5 meter reach.
Float Low Loader - Ford Louisville LTS 9000 - Carries full range of attachments
Attachments:
- Superbreaker - rock hammer/rock breaker
S26 Rammer super breaker with extension of 900mm long moil. Largest breaker able to be fitted to a backhoe. The versitality of this superbreaker when used in combination with the Tilt Quitch allows a 90 degree angle, therefore can dig a square hole with straight sides. Clearing the underside of bridges or tunnels. - P7 Digga Borer
Augers 350mm 450mm 600mm extension to 5 meters depth. - Pneuvibe Compaction Plate
450mm - meets government standard compaction rate required for roadwork - more than 100% compaction registered by Department of Main Roads on Brisbane's motorways. The Compaction Plate and the Tilting Quitch Hitch was used in the road widening on the Logan Motorway where flat compaction was not a solution. - Extender hoe
This allows the backhoe to reach 5 metres from the machine to reach areas that normally an 12 ton excavator would be used - but with more flexibility in moving around sites than an excavator. - Powertilt Quick hitch
Enables attachments to be used in a tilt position. - Levelling Spreader Bar (3m x 2.3m)
The perfect clean up and finish in half the time. - Rollover forks
Used to upload trucks, move pallets of block or bricks, pipes and conduit up to 1.5 tonnes. - Buckets range from 300 to 1800
Teeth guards on a selection of buckets. - Rock ripper
Rock ripper.